1965 Shelby Cobra Copper bodied Roadster by Kirkham. This magnificent Cobra was built by Kirkham as an anniversary special. It was their intention to build a dozen of the cars, but the plan was aborted leaving only this one single example. Given that Kirkham’s intention was to promote their cars, this one was built with the full complement of options using only the finest materials and workmanship. This example is a complete rolling chassis needing only engine and transmission. This can be done upon purchase or the car can be sold as-is allowing you to install the engine of your choice.
Options:
Completely wired and plumbed – sold as a complete roller. Needs only your choice of engine and gearbox.
- Polished Copper body on Stainless steel frame built in Kirkham’s Warsaw Factory.
- Stainless steel roll bar
- Stainless frame for hood, trunk, and doors
- Polished stainless heat shield box
- Billet gas tank straps
- 42 gallon fuel tank
- Wheel-well protection foam (uninstalled)
- Wool carpet
- Windshield wings
- Billet aluminum brake, clutch, and accelerator pedals
- Leather dash
- Four point seat harness
- Battery Cut-off
- Oil cooler Assembly
- FE Motor Mounts
- Billet aluminum distributor hold down and carburetor accessories
- Fuel filter and fittings
- Fuel pressure guage isolator
- Billet aluminum intake manifold breathers
- Oil vapor separator tank
- Stainless steering shaft and U-joints
- Shift lever handle
- Kirkham differential aluminum upgrade
- Drive shaft and safety loop
- Half shafts
- Billet aluminum brake and clutch reservoirs
Titled in SC as 1965 Cobra 427 Replica
Via
No comments:
Post a Comment